Reinforce your fire pit with Construction Adhesives

How To Install A Fire Pit Using LIQUID NAILS

To install a fire pit, all you need is your block of choice and LIQUID NAILSFUZEITAll Surface Construction Adhesive (LN-2000) to get the job done. LIQUID NAILS* FUZEIT* has an extreme temperature resistance, and will secure your blocks in place.

Step 1.

Identify an area at least 10 feet from your home, with no overhanging branches or nearby trees. Make sure you check your local fire regulations before you start your project for any additional considerations.

Step 2.

Measure out your desired surface area. Depending on your surface, you may need to prepare the ground by removing the top layer of soil, or creating a sand bed.

Step 3.

Lay blocks in your desired arrangement, placing a 1/4-inch continuous line (bead) roughly 1.5 inches from the front and back edges of the blocks.

LIQUID NAILS FUZE*IT should not come in contact with open flame.

Step 4.

Allow the adhesive to cure for 24 hours before enjoying your new fire pit.

Please refer to the Product Label, Technical Data Sheet (TDS) or Safety Data Sheet (SDS) for safety and detailed application instructions.

SEE MORE HELPFUL HOW-TO ARTICLES SEE OUR FULL LINE OF PRODUCTS

Contact LIQUID NAILS^{^®}

We know there can be a lot of questions around construction adhesives. We're here to help your project be a success.

BRIGHTEN UP YOUR MAILBOX!

* What Segment do you serve most?

To install a fire pit, all you need is your block of choice and LIQUID NAILS FUZE*IT All Surface Construction Adhesive (LN-2000) to get the job done. LIQUID NAILS FUZE*IT has an extreme temperature resistance, and will secure your blocks in place.