Selecting the right construction adhesive to install a mirror

Choosing the right adhesive is critical for a mirror installation. The silver backing on the back side of your mirror is extremely sensitive to adhesives. Some adhesives can burn through the silver backing, and damage your mirror. We recommend using LIQUID NAILS FUZE*IT All Surface Construction Adhesive (LN-2000).

Step 1.

After you choose your mirror-friendly adhesive, measure your mirror. If you mirror is over 2’ x 2’, make sure there is a base or lip for the mirror to sit on at the bottom of the mirror. Mirrors 2’ x 2’ and over must have physical fasteners like mirror clips, or L or J hooks so the adhesive cures properly.

Step 2. 

Apply a 1/4-inch continuous line of adhesive (bead) every 4 to 6 inches across the back of the mirror vertically. This allows air flow behind the mirror so moisture does not get trapped.

IMPORTANT NOTE: Do not seal around edges.

Step 3.

Press your mirror into position.  Allow 24- 48 hours for your mirror to cure.
 

SEE MORE HELPFUL HOW-TO ARTICLES SEE OUR FULL LINE OF PRODUCTS